Products Description
Product Description
The Over the Range Hood HA636-MG is a 90cm canopy hood built for one specific job: keeping a busy, high-heat kitchen breathable. Instead of chasing a bigger headline number, it pairs a genuinely deep canopy with an inverter-driven motor that holds its pressure on long, shared or heavily used duct runs - the conditions where most slim hoods fall short. The result is a hood that fits inside a standard wall cabinet yet clears a wok burner without leaving a lingering haze.

1800Pa Air Pressure - Built for Duct Runs That Fight Back
The MAX18 high-pressure core technology combines three components: an SP3.0 full-DC inverter motor, an owl-wing bionic impeller, and a straight-through booster duct. Together they hold 1800Pa of static pressure - the figure that actually decides whether fumes leave the building when a shared riser is packed with neighbours' exhaust. Blocked ducts and backflow are no longer your problem to solve.
2800m³/h Airflow - Captured at the Source
A wide-diameter impeller is driven at high speed to move 2800m³/h of air. That is enough to sweep a screaming-hot stir-fry clean in the seconds before smoke has a chance to climb past the canopy edge.
An 895mm Canopy With a 422mm Reach
The capture zone measures 895mm across, with a 794mm active intake, a 422mm span front-to-back, and a 90° wing opening. The wings travel toward the pan rather than sitting flat, so rising smoke meets the hood instead of drifting around it - a simple geometry that matters more in a real kitchen than any number on a spec sheet.

310mm Tall, 360mm Deep - Made to Disappear
Needing only 360mm of depth, the chassis slots under standard wall units. At 310mm high, it leaves clear sightlines and headroom, so a compact galley or a low-ceiling flat still feels open. Fitting a new kitchen or refreshing an old one, no cabinet surgery is required.
Heat-Based Self-Cleaning Every 60 Hours
After 60 hours of accumulated runtime - and 30 minutes switched off - the hood runs its own 75°C thermal cycle, loosening baked-on grease from the internal ducting so airflow stays where it started. Servicing drops to occasionally removing the filter and emptying the cup.

Luxury Shadow Grey Nano-Crystal Glass
The panel borrows a lotus-leaf structure: a micro-nano surface texture with a controlled grain that repels water, oil and fingerprints. A matte, low-sheen grey finish means no mirror glare over the hob and no daily polishing ritual - a single pass with a cloth brings it back.

Controls That Anticipate You
1.Full-colour touch panel - an illuminated interface that reads bright and clear at a glance
2.Wave control - a hand sweep above the panel switches the hood on or off with wet, doughy or greasy hands safely at your side
3.Hob-to-hood link - ignition at the burner starts extraction instantly; no reach, no delay
4.Delayed stop - the fan keeps running three minutes past flame-off to pull the last of the smoke, then powers down on its own

Small Details That Earn Their Keep
1.Dishwasher-safe mesh filter - lifts out in one motion, so hand-scrubbing is off the list
2.LED ambient light - low-glare illumination that lets you see the actual colour of what you are cooking
3.Smooth-glide oil cup - generous capacity, slides out for a rinse without a struggle
Specifications
| Product Name | Over the Range Hood | Model No. | HA636-MG |
| Body Material | Grey Coated SPCC + Matte Gray Glass | Levels of Speed | 3 Speeds |
| Maximum Airflow | 2800m³/h | Motor Power | 268W |
| Noise Level | 63dB | Motor Type | Full Sealed Metal BLDC Motor |
| Fan Type | Metal Fan with Teflon Finish | Control Type | Sensor Touch with Gesture Control |
| Filter | Gray Coated SPCC Mesh Filter | Light Type | ≤1*2W LED |
| Venting Size | 185mm | Air Pressure | 1200Pa |
| Rated Voltage/Frequency | 220V~,50Hz | Rated Input Power | 270W |
| Product Size | 895*460*580(W*D*H)(mm) | Packing Size | 955*637*523(W*D*H)(mm) |
| Loading Qty | (20GP/40GP/40HQ)=84/168/210 | G.W/N.W | 24.4kg/20kg |
Product Dimension Drawing(if any)

Installation View

FAQ
Q1: What makes the HA636-MG different from an Over the Range microwave hood?
A typical Over the Range (OTR) unit pairs a microwave with a small blower, so ventilation is a compromise. The HA636-MG is a dedicated hood: 1800Pa static pressure and 2800m³/h airflow, driven by an inverter motor that keeps its pressure even when the shared flue is crowded. You get proper extraction without giving up cabinet space.
Q2:How does it handle apartment buildings with shared or long duct runs?
This is exactly where the MAX18 high-pressure system earns its keep. Static pressure - not raw airflow - determines whether fumes overcome duct resistance, and at 1800Pa the hood maintains steady discharge during peak cooking hours while the check-style duct design stops smoke from drifting back down into your kitchen.
Q3: Will it fit a standard 900mm wall cabinet without modification?
Yes. The chassis is 360mm deep and 310mm high, sized for standard upper cabinets, and it suits both new installations and refresh projects where the existing cabinetry stays. Check the installation drawing for the exact bracket drilling template.
Hot Tags: over the range hood, China over the range hood manufacturers, suppliers, factory, 600 cfm range hood, 600mm Cooker Hood, modern kitchen hood, Quiet Cooker Hood, recirculating range hood 90cm, Small Kitchen Vent Hood